Notes On Safety; Factory Mode; Opening With Master Code/Administrator Code (First Time Opening); Locking - Wittkopp SmartCam Quick Start

CLAVIS Deutschland GmbH
Grüner Weg 38
34117 Kassel
SmartCam - Quick start

1 Notes on safety

• Due to security reasons change the factory code of 1 2 3 4 5 6 immediately.
• For your new code, do not use any personal data like birthdays or any other data, which could be known by knowledge of
your person.
• Simple codes that can be guessed easily i.e. 1 2 3 4 5 6 must not be used.
• Your code has to be secret.
• Don't write down your code.
• Don't safe your code on your PC, a DVD, a USB-stick or your mobile.
• Change your code frequently for example every three months.
• After entering the new code, the electronic lock should be opened and locked several times with the safe door opened.
• After each locking doublecheck if the safe is closed.

1.1 Factory mode

• Upon delivery the lock is factory setted on opertion mode K1/number 10:
• The initial factory codes are:
- Master factory code: 1-2-3-4-5-6 (valid for all operation modes)
- Administrator factory code: 6-5-4-3-2-1 (valid for all operation mode K1)
Detailed installation/operating instructions are available for download on our website.

2 Opening with master code/administrator code (first time opening)

1. Press and hold the key "8" for approx. 3 seconds. Then the green LED flashes permanently.
2. Enter your 6-digit code.
3. Turn the knob within 3 seconds into opening position.

3 Locking

1. Close the door at the safe and enter any key. Turn the knob within 3 seconds into locking position. The lock is closed.

4 Programming a user code

The administrator is able to program a user code, but not vice versa.
1. Press and hold the key "1" for approx. 3 seconds. Then key the green LED flashes permanently.
2. Enter your 6-digit administrator code.
3. Enter the 1-digit user PIN which has to be programmed (between 1 and 9).
4. Enter the new 4-digit user code.
5. Re-enter the new 4-digit user code.

5 Opening with user code

1. Enter your 4-digit code.
2. Turn the knob within 3 seconds into opening position.

6 Changing the code

1. Press and hold the key "0" (user code) / "2" (master/administrator code) for approx. 3 seconds.
Then the green LED flashes permanently.
2. Enter your old 4-/6-digit code.
3. Enter your new 4-/6-digit code.
4. Re-enter your new 4-/6-digit code.
Rel. 1.0
Telefon: +49 (0)561 988 499-0
E-Mail: info@tresore.eu
Internet: www.tresore.eu
www.tresorschloss.de
01.06.2016
© Carl Wittkopp GmbH - Errors and omissions excepted
Quick start no. 600-0008-00-0