Table of Contents
Advertisement
Installation instructions
BEFORE YOU BEGIN, READ THE FOLLOWING INSTRUCTIONS
COMPLETELY AND CAREFULLY.
Installing
your microwave oven
1.
Empty the microwave
oven and clean
inside
it with a soft, damp
cloth. Check for damage
such
as misaligned
door, damage
around
the door or
dents inside the oven or on the exterior. If there is
any damage,
please
do not operate
the unit until
it has been checked
by an authorized
Whirlpool
service
technician
and any repairs made.
I
I
I
3. Do not block
the vent or air intake
open-
ings on the rear of the oven. Blocking
vent or air
intake openings
can cause damage
to the
oven and poor cooking
results. Make sure the
microwave
oven legs are in place
to ensure
proper
air flow.
5. Read and follow the ELECTRICAL REQUIRE-
MENTS and GROUNDING
INSTRUCTIONS
before
plugging
in and operating
the microwave
oven.
2. Put the oven on a car-t, cyunter, table or shelf
that is strong enough
to hold the oven and the
food and utensils you put in it. (The control
side
of the unit is the heavy
side. Handling
can be
tricky.)
The weight
of the oven is approximately
41
Ibs. (18.6 kg).
TOP
1 inch 1
SIDE
1 inch
+
SIDE
1 inch
f
4. Do not install the microwave
oven so that
both sides and the top are flush with walls,
shelves
or cabinets.
Both sides and the top
must have at least 1 in. (2.54 cm] clearance
for
proper operation.
Do not install the oven next to or over a conven-
tional surface unit or in any area where exces-
sive heat and steam are generated.
This could
damage
the outside of the cabinet.
6.
Electrical
requirements
Observe
all governing
codes
and
ordinances.
Al20 Volt, 60 Hz, AC only,15 Amp fused elec-
trical supply
is required.
[Time-delay
fuse is
recommended.)
It is recommended
that a
separate
circuit serving
only this appliance
be provided.
DO NOT use a male to female
extension
cord.
Advertisement
Table of Contents
