Roto Safe Eneo Series Manual

Roto Safe Eneo
Roto Safe Eneo
Note
Incorrect installation, maintenance or
operation can lead to hazardous situations.
This extract is not a replacement for complete
documentation. Failure to observe this
documentation discharges the hardware
manufacturer from their liability.
Note the complete installation, mainte-
u
nance and operating instructions (IMO).
The complete documentation for this extract is as
follows:
Roto Safe Eneo installation instructions:
■
C | CC | CF: IMO_438
Control Unit: IMO_288
Roto Safe Eneo brief instructions:
■
Power supply unit specifications (third-party
product): SUG_3
General information: SUG_9, SUG_10
Connection Diagrams
■
Roto Safe Eneo: IMO_310
DANGER
Risk of death caused by electric
shock
Current can lead to fatal injuries.
Installation and maintenance work may
u
only be carried out by qualified electri-
cians.
Observe and comply with the respective
u
national regulations (in Germany VDE
0100 and others).
When laying the network connection
u
cable on-site, all-pole safety isolation
must be established.
Only carry out work when the power
u
supply is disconnected.
Subject to change.

Technical data

Roto Safe Eneo drive
Voltage
Continuous current
consumption
Current consumption
Relative air humidity
Temperature
Output relay load
Standards
Cable junction (on the sash side)
Max. voltage
Max. current
Line
Line length on the connector
side
Degree of protection in
accordance with DIN 40050
Temperature when idle
Cores
Power supply unit
DC voltage
Rated current
Voltage adjustment range
Voltage range
Frequency range
Temperature
Relative air humidity
INFO
If a different power supply unit is used,
ensure that it has 24 V and 2.5 A at the
output (see SUG_3).
Roto Safe Eneo
24 V DC (±5%), 2.5 A, SELV output voltage
according to EN 60950-1
25 mA
1.5 A (peak 2.3 A)
≤ 93%
–25 to +60 °C (transport –25 to +70 °C)
Max. 40 mA, flyback diode for inductive load
present internally
EN 60 730-1,
EN 50090-2-2
Low Voltage Directive complied with,
CE conformity
48 V DC
3 A
LiF9Y11Y, six-pole version,
Ø 4.9 mm, grey
4 m
IP67 (when inserted)
–40 to +75 °C
(transport –5 to +50 °C)
0.34 mm 2 (white, green, brown,
yellow, pink, grey)
24 V (output)
2.5 A (output)
21.6 to 26.4 A (output)
88 to 264 V AC, 124 to 370 V DC (input)
47 to 63 Hz (input)
–20 to +60 °C
20% to 93%
SUG_11_EN_v0 · 04 / 2019 · 1