Table of Contents
Advertisement
OFSR-X OptiFiber Smart Remote Options
Users Manual
Powering the Smart Remote
To charge the battery, connect the ac adapter provided,
as shown in Figure 3. You may charge the battery when it
is attached or detached from the smart remote.
The ac adapters for the OptiFiber tester and the smart
remote are interchangeable.
The battery charges fully in about 4 hours with the smart
remote off. A fully-charged battery lasts for at least 12
hours of typical use.
The battery will not charge at temperatures
outside of 32 °F to 113 °F (0 °C to 45 °C). The
battery charges at a reduced rate between 104 °F
and 113 °F (40 °C and 45 °C).
12
Note
The LED near the ac adapter connection indicates the
following:
•
Red: battery is charging.
•
Green: battery is charged.
•
Flashing red: The battery did not reach full charge
within 6 hours. Verify that the battery was within the
temperature range given above during charging and
that the correct ac adapter was used. Disconnect then
reconnect ac power and try charging the battery
again. If the battery does not charge the second time,
it should be replaced.
To determine the smart remote's battery status, watch its
LEDs at the end of the power-up cycle. Refer to
Figure 3.
The accuracy of the smart remote's battery gauge may
drift over time. If the battery status information seems
incorrect, reset the battery gauge as described on
page 21.
Advertisement
Table of Contents
