Table of Contents
Advertisement
A
Button for activating the visual fault locator (B) and
output port (D). See "Using the Visual Fault Locator" on
page 15 and "Using the Smart Remote as an Optical
Source" on page 18.
B
Universal fiber connector (with dust cap) for the visual
fault locator output. The connector accepts 2.5 mm
ferrules. The LED below the connector indicates the
locator's mode (continuous or blinking).
C
SC input connector with dust cap. Receives optical signals
for loss, length, and power measurements.
D
E
Figure 2. Fiber Module Features (cont.)
SC output connector with dust cap. Transmits optical
signals for loss and length measurements.
The LED below the connector is red when the output is
active at 850 nm (DTX-MFM) or 1310 nm (DTX-SFM) and
green for 1300 nm (DTX-MFM) or 1550 nm (DTX-SFM).
W * Warning
Never look directly into optical output connectors (B
and D). Some sources produce invisible radiation
that can permanently damage your eyes.
Laser safety label.
Getting Acquainted
awl09i.eps
11
Advertisement
Table of Contents
