Table of Contents
Advertisement
The wifi/bt module used on ROCK960s is AP6356s from AMPAK Technology. The
AP6356s module complies with IEEE 802.11 a/b/g/n/ac 2x2 MIMO standard and it
can achieve up to a speed of 867Mbps with dual stream in 802.11n to connect the
wireless LAN.
802.11a/b/g/n/ac dual-band radio with virtual-simultaneous dual-band operation
Dual-stream spatial multiplexing up to 867 Mbps data rate
Supports 20, 40, 80 MHz channels with optional SGI(256 QAM modulation)
Supports IEEE 802.11 ac/n beam forming
The ROCK960 Board also has a RF connector to connect the external antenna or
other RF device. If you want to use this function, you should change the 0ohm
resistor directions besides the antenna.
Bluetooth
Bluetooth specification V2.1+EDR, 3.0+HS and 4.1+HS compliant
Integrated PA with 8dBm (class 1) transmit power
Typical Rx sensitivity: GFSK -94dBm, DQPSK -93dBm, 8-DPSK -87.5dBm.
Display Interface
HDMI
RK3399 support HDMI 1.4 and 2.0, up to 10-bit depth color mode, up to 1080p at
120Hz and 4Kx2K at 60Hz HDTV display resolutions and up to QXGA graphic
display resolutions.
MIPI-DSI
The 96Boards specification calls for a MIPI-DSI implementation via the High Speed Expansion
Connector.
The ROCK960 Board implements a 4-lane MIPI_DSI interface meeting this requirement. It can
support up to FHD(1080p@60fps). The ROCK960 Board routes the MIPI_DSI interface signals to
the MIPI_TX1/RX1 interface of the RK3399. The MIPI_TX1/RX1 can also be configured as MIPI
CSI by software.
Camera Interface
The 96Boards specification calls for two camera interfaces.
The ROCK960 Board supports two camera interfaces, one with a 4-lane MIPI_CSI interface and
one with 2-lane MIPI_CSI interface, meeting this requirement. The 4-lane MIPI_CSI interface can
support 13M camera.
USB Ports
Advertisement
Table of Contents
