Table of Contents
Advertisement
Limitless™ WDRR Receiver
7.4 Purge Mode
Purge mode is used to remove a Limitless™ input that has a lost RF link with the WDRR (see Section 8.3.1 for
possible causes and Section 5.2 for determining which Limitless™ switch(s) have a lost RF link). Only one
Limitless™ input with a lost RF link may be purged at a time. The WDRR will choose the first Limitless™ inputs in
the Sequence of #1 to #14 that has a lost RF link. Repeat the purge process if there are more Limitless™ inputs to
purge (i.e. if the user has ten Limitless™ switches paired to the WDRR and he/she needs to purge Limitless™
sequence/output #3, 5, and 7; the first sequence #/output to be purged is #3, repeating the process will purge #5,
etc.)
Note, a Limitless™ input with a good RF link cannot be purged. If a Limitless™ input with a good RF link is
intended to be purged, remove battery first as this will cause a 'lost RF' indication after a few minutes.
Ensure proper power is applied to the WDRR (green power LED illuminated) before proceeding with this procedure.
Step
Action
1
Press the Function button
yellow, red configuration LEDs
2
The WDRR will then indicate a purge with the red
Limitless™ input that is being purged. Once the purge is completed, all LEDs will not illuminate for one
second and then the WDRR will return to normal operation.
3
Repeat above steps if necessary to purge more Limitless™ input(s).
7.5 Factory Reset Mode
Factory reset mode is used to remove/un-pair all Limitless™ inputs that were previously paired to the WDRR and
thus it is being returned to the as-manufactured condition. Ensure proper power is applied to the WDRR (green
power LEDs illuminated) before proceeding with this procedure.
Step
Action
1
Press the Function button
well as the fourteen tri-color LEDs
Immediately release the function button. The configuration LEDs
the WDRR has been factory reset. Refer to Figure 2.
2
Verification of proper reset can be confirmed by operating each of the Limitless™ inputs originally paired to
the reset WDRR. Repeat procedure if the Limitless™ inputs are still indicating an output on the WDRR.
3
Turn power off to WDRR.
7.6 Abort Mode
The Abort mode provides a last chance to cancel the operation before the WDRR goes into Factory Reset mode. If
the operator holds the function button
Factory Reset mode, he/she can immediately release the function button
WDRR immediately returns to normal operation.
20
www.honeywell.com/limitless
on WDRR for approximately eight to 12 seconds at which time the green,
will be flashing. Refer to Figure 2.
on WDRR until the green, yellow, red configuration LEDs
. Continue to hold the Function button on WDRR until the LEDs turn off.
for more than 12 seconds, but does not wish to put the WDRR into the
LED flashing the sequence number (1 to14) of the
will turn on and then off indicating that
to put the WDRR into Abort mode. The
50063987
Issue 1,
are flashing as
Hide quick links:
Advertisement
Table of Contents
