Adjusting The Interior Fittings (Refrigerator Section); Moving The Shelves; Removing The Perfectfresh Zone Drawers - Miele KFN 16947 D ed/cs Operating And Installation Instructions

Adjusting the interior fittings (refrigerator section)

Moving the shelves

Stoppers prevent the shelves from be-
ing dislodged by mistake.
 The shelves can be adjusted accord-
ing to the height of the refrigerated
goods:
1. Lift the shelf up slightly at the front.
2. Pull it forwards a little and lift it until
the notch at the side is in line with
the shelf support. It can then be
raised or lowered to the required
level.
The raised edge on the protective strip
at the back must face upwards to pre-
vent food from touching the back of
the appliance and freezing to it.
40
Removing the PerfectFresh
zone drawers
The drawers in the PerfectFresh zone
are on telescopic runners, and can be
removed for filling, emptying or cleaning
purposes:
Remove the bottle shelf from the ap-
pliance door to make it easier to take
out the drawers.
 Pull the drawers out as far as they will
go.
 Holding the sides of the drawer at the
back, lift it up and then pull it for-
wards and out.
Push the runners back in again to
avoid damaging them.
 Carefully pull the lid between the
drawers slightly forwards and take it
down and out.