GOWESTY Yakima Installation Instructions

These instructions and the images herein are proprietary. Any unauthorized reproduction is prohibited.
This kit installs Yakima roof rack tracks onto your Eurovan Winnebago camper.

Tools Needed

Tools Needed Tools Needed Tools Needed
Phillips screwdriver
•
Drill
•
7/32" and 3/8" drill bits
•
Exterior grade silicone sealant
•
Tape measure
•
Tape (masking tape works well)
•
1. Lay each rail in place in the indented grooves of the pop-up portion of your roof.
2. Position the rear edge of the rails (without end caps) so they are 3" forward of the
rearmost flat part of the groove in your roof (measure from where the roof starts
curving down). See the diagram below for reference.
3. Slide the rails towards the outside of the grooves in your roof. The inside of the
rails should be 40.5" apart and evenly positioned side to side. Tape down the
rear of the rails to secure their position.
4. Adjust the front of the rails so they are 40.5" apart and evenly positioned side to
side. Carefully verify that the rails are exactly parallel. Securely tape the rails
down in several places, but don't cover any of the mounting holes.
5. Check again to make sure the rails are parallel!
6. Using rails as a guide, drill through each hole with the 7/32" drill bit (EXCEPT
the hole that is 5 the hole that is 5 the hole that is 5 the hole that is 5
that will interfere with the install). See the diagram below for reference. that will interfere with the install). that will interfere with the install). that will interfere with the install).

WARNING

WARNING WARNING WARNING - - - - Do not drill through both layers of your top! Do not drill through both layers of your top! Do not drill through both layers of your top! The top layer is about 1/8" Do not drill through both layers of your top!
thick. After you break through the first layer, STOP DRILLING
7. Remove the rails, enlarge the holes to 3/8", and place a rubber nut insert into
each hole. A bit of silicone sealant is recommended to ensure a watertight fit.
8. Put the rails back on the roof. Place the end caps (supplied with the rails) onto the
rails and start the stainless screws into the inserts. Once everything is lined up and
looking good, tighten all screws until they are snug. No need to crank them down
with a ratchet, a nice firm twist with a screwdriver is all that is required.
GoWesty Camper Products • 1119 Los Olivos Ave, Los Osos, CA 93402 • 888-469-3789 • www.gowesty.com
EVC-YAKIMA-HARDWARE
Eurovan Winnebago Yakima Roof Rack Install
DI DI DI DISCLAIMER: SCLAIMER: This kit has been designed for easy
SCLAIMER: SCLAIMER:
installation. However, it does involve drilling into the
roof of your vehicle. The installation of this kit is not
within
instructions carefully and decide if installing it is for
you. If not, please take your vehicle to an installation
professional.

INSTALLATION

th th th th from the rear!! There is a sup from the rear!! There is a sup from the rear!! There is a sup from the rear!! There is a support beam in this location
Page 1 of 2
everyone's ability.
port beam in this location port beam in this location port beam in this location
STOP DRILLING. . . . STOP DRILLING STOP DRILLING
Read through these
(EXCEPT
(EXCEPT (EXCEPT