Advertisement
Installation
Read the following descriptions together with the Installation Guide of the camera.
Note:
• When a smoke type dome cover is used, the IR LED irradiation distance and the illuminance
level are lower than for a standard clear type dome cover.
Check the settings after attaching the enclosure.
Step1
Loosen enclosure fixing screws (3 places),
and remove the enclosure from the camera.
<Outdoor camera>
Loosen the screws using the bit (camera accessory).
<Indoor camera>
Loosen the screws using a Phillips screwdriver.
* The right illustrations are examples of outdoor use
camera.
Step2
Remove the dome cover.
q
Remove the fixing screws (3 pcs.) that secure the dome cover anchor bracket to the enclosure.
w
Remove the dome cover anchor bracket , the dome cover and rubber ring (outdoor camera only).
Note:
• These fixing screws (3 pcs.), the dome cover anchor bracket and rubber ring (outdoor camera
only) will be used again in step3.
<Outdoor camera>
Bit (camera accessory)
Enclosure fixing
screw (3 places)
<Indoor camera>
Dome cover
anchor bracket
Fixing screw
(3 pcs.)
Dome cover
Enclosure
Rubber ring
Step3
Replace the dome cover.
q
Remove the cover film from the outside of the dome cover (this product). Keep the removed
cover film for following step. (Take care not to damage the outside or inside of this product.)
w
Attach the rubber ring to the enclosure. (Outdoor camera only)
e
Attach this product to the enclosure.
r
Using the fixing screws (3 pcs.) that were removed in step2, secure the dome cover anchor
bracket to the enclosure. (Recommended tightening torque: 0.40 N·m {0.30 lbf·ft})
Attach the cover film removed in q to the outside surface of this product.
t
Enclosure
<Outdoor camera>
Note:
• When attaching, make sure that the rubber ring is properly set in the groove of the enclosure.
(Outdoor camera only)
• Do not remove the dust guard sponge adhered to the dome cover anchor bracket.
(Indoor camera only)
Step4
Attach the enclosure to the camera.
Tighten the enclosure fixing screws (3 places) using the bit (camera accessory) or Phillips screw-
Dust guard
driver.
sponge
Recommended tightening torque: 0.70 N·m {0.52 lbf·ft}
Refer to the Installation Guide of the camera for more information about installing the camera.
<Indoor camera>
Dome cover
anchor bracket
Fixing screw
(3 pcs.)
Dome cover
Enclosure
Rubber ring
Dust guard
sponge
Advertisement
