Rear Fender Installation; Cargo Bed; Cargo Bed Removal - Husqvarna HUV 4214 2009 Maintenance And Service Manual

4

Cargo Bed

1
1. Locking Pin 2. Bed Locking Pin Holes
K-00221
Figure 4-36 Bed Locking Pin
3. Remove fender from vehicle.

REAR FENDER INSTALLATION

1. Install rear fender in the reverse order of removal.
2. Tighten bolts to 35 in-lb (4.0 N·m).
CARGO BED
See General Warning on page 1-2.
NOTE: Cargo bed removal and installation will be easier with an assistant.

CARGO BED REMOVAL

1. Raise the cargo bed and engage the cargo bed lock pin (1) located at the driver side cargo bed hinge (Figure
4-38, Page 4-23).
2. Loosen the cargo bed pivot bolts (2), but do not remove.
Page 4-22 2009-2010 HUV 4214, HUV 4414, and HUV 4414X Maintenance and Service Manual
2
1154
Figure 4-37 Rear Fender Removal
BODY AND TRIM