Front And Rear Body Repair; Minor Scratches And Surface Blemishes; Small Scratches That Cannot Be Buffed Out; Gouges, Punctures, Tears, Large Scratches, And Abrasions - Husqvarna HUV4210 2005 Series Maintenance Service Manual

Gasoline and electric vehicles 2005-2006

Table of Contents

BODY AND TRIM

CAUT ION

• To prevent damage to the vehicle when removing difficult stains or heavy soiling, remove the

seat bottom from the vehicle first.

FRONT AND REAR BODY REPAIR

See General Warning, Section 1, Page 1-1.

For minor scratches or blemishes in the body that do not penetrate the finish:

1. Thoroughly clean the affected area using a strong, non-abrasive detergent and hot water, then clean with

Ultra-Kleen

2. Lightly buff imperfection with a clean soft cloth or buff pad. Do not use any kind of rubbing (abrasive) com-

pound on body assemblies.

3. Wax the entire body part to restore luster and weather protection.

1. Thoroughly clean the affected area with alcohol and then dry thoroughly.

2. Using 240 grit or finer sandpaper, lightly sand the scratch to feather the edges. Finish sand the scratch

with 320 grit or finer paper to remove gloss from the surface. Sand as little body surface as possible

beyond the scratch. See following CAUTION.

CAUT ION

• Be careful not to sand completely through the finish to the body material.

3. Using the brush provided with the touch-up paint apply paint to the scratch. Multiple layers of paint may

be required to fill the scratch.

4. Allow paint to dry completely (approximately 10-20 minutes), then lightly buff the imperfection.

5. Wax the entire body part to restore luster and weather protection.

Touch-up is not recommended. Replace the entire body part or have it repaired by a professional paint and

body repair shop with experience repairing TPO bodies.

Page 4-2

2005-2006 HUV4210-G, 4210-E, 4210-GXP, 4210-EXP Maintenance and Service Manual

Solvent Cleaner to remove any oil-based contaminants.

Front and Rear Body Repair

Table of Contents