Cargo Bed Installation - Husqvarna HUV 4214 2009 Maintenance And Service Manual

BODY AND TRIM
1
2
1393
Figure 4-38 Cargo Bed Pivot Bolts
3. Lower the cargo bed into the lowest position, but do not engage the cargo bed latch.
4. Remove the two cargo bed mounting lock nuts, washers and pivot bolts.
5. With the help of an assistant, lift the cargo bed and remove from vehicle.

CARGO BED INSTALLATION

1. With the help of an assistant, lift the cargo bed and place it in the lowered position on the vehicle. Align the
cargo bed hinge tabs with mounting holes in the frame rails. Secure the cargo bed using the two cargo bed
mounting lock nuts, washers and bolts. Install bed locking pin into hinge to keep the bed from falling. Tighten the
hardware to 15 ft-lb (20.4 N·m).
2. Place bed locking pin in the storage holes and then raise and lower the cargo bed to ensure smooth operation.
2009-2010 HUV 4214, HUV 4414, and HUV 4414X Maintenance and Service Manual
4
Cargo Bed
Page 4-23