Section 4 - Body And Trim; Cleaning The Vehicle; Seat Cleaning - Husqvarna HUV4210 2005 Series Maintenance Service Manual

Gasoline and electric vehicles 2005-2006
Table of Contents

Advertisement

SECTION 4 – BODY AND TRIM
ý
DANGER
• See General Warning, Section 1, Page 1-1.
ý
WARNING
• See General Warning, Section 1, Page 1-1.

CLEANING THE VEHICLE

See General Warning, Section 1, Page 1-1.
CAUT ION
• Do not use detergents or cleaning solvents that contain ammonia, aromatic solvents, or alkali
materials on body panels or seats.
• Do not allow battery acid to drip on body panels. Battery acid will cause permanent damage.
Wash spilled battery acid from body panels immediately.
These vehicles are equipped with ABS front body and TPO rear bodies. Use only commercially available
automotive cleaners with a sponge or soft cloth for normal cleaning. A garden hose at normal residential
water pressure is adequate.
We do not recommend any type of pressure washing or steam cleaning. Such a process (especially if the
body has been removed) will expose electrical components to moisture. Moisture entering electrical compo-
nents can result in water damage and subsequent component failure.
Use non-abrasive wax products. Battery acid, fertilizers, tars, asphalt, creosote, paint, or chewing gum should
be removed immediately to prevent possible stains. See following NOTE.
NOTE: Dispose of waste water properly.

SEAT CLEANING

To preserve seat appearance, clean regularly with mild soap or detergent applied with a sponge or soft cloth.
Use a soft bristle brush to clean areas that are especially soiled. Use the following guidelines:
Light Soiling: A solution of 10% liquid dish soap and warm water applied with a soft, damp cloth is rec-
ommended. A soft bristle brush may be used if necessary. Wipe off any residue with a water dampened
cloth.
Difficult Stains: Dampen a soft, white cloth with a solution of 10% household bleach (sodium
hypochlorite) and 90% water. Rub gently to remove stain, then rinse with a water dampened cloth to
remove bleach concentration.
More Difficult Stains: Perform previous procedure using full-strength bleach, or allow bleach to pud-
dle on affected area for approximately 30 minutes. Rinse with a water dampened cloth to remove any
remaining bleach concentration. See following CAUTION.
2005-2006 HUV4210-G, 4210-E, 4210-GXP, 4210-EXP Maintenance and Service Manual
4
Page 4-1

Advertisement

Table of Contents
loading

Table of Contents