Bullet tools EZ Shear 113 Quick Start Manual

Quick Start Guide
for EZ Shear Models #113, #120, #213
In the Box:
1. Power Assembly 5. Tail
1a. Safety Lock pin 6. Rails x 2
2. Handle Assembly 7. Hone Stone
3. Fence 8. Mounting Brackets x 4 (213 only)
4. Table 9. Hardware Kit
ASSEMBLING YOUR SHEAR
Tools needed: #2 & #3 Phillips head screwdrivers and a 1/2" (13mm) socket or wrench.
IMPORTANT! Start all screws BY HAND when assembling your shear. This will help avoid cross-threading.
1. ATTACH RAILS
Attach rails to Power Assembly base using
Item A screws, fitted with Item B star washers.
Power Assembly
3. ATTACH TABLE
A. Attach front of table to base, using Item D screws.
Tighten with #3 Phillips.
B. Attach back of table to tail using Item E screws.
Tighten with #2 Phillips.
4. ATTACH HANDLE
Insert handle into slot. Insert Item F screws
and tighten with 1/2" (13mm) wrench.
4
A. (4) M6 x 65mm PH Phillips Machine Screws
B. (4) M6 Star Washers
C. (6) M6 x 25mm PH Phillips Machine Screws
D. (5) M6 x 16mm FH Phillips Machine Screws
The Hardware Kit is used in multiple models. Your Shear may not use all of the items listed.
(and mounting brackets
if applicable)
1
5.
Align fence with one of two hole sets on the table: at 90° or at 45°.
Use Item C screws with Item G wingnuts to fasten securely.
Item F
In the Hardware Kit:
2. ATTACH TAIL
Attach tail to rails using Item C screws.
Make sure holes in tail are facing up.
2
3A
Item D
ATTACH FENCE
Item C
Item G
E. (4) #10 x 1 FH Phillips Self Tapping Screws
F. (2) M8 x 50mm Hex Bolts
G. (2) M6 Wing Nuts
(and mounting brackets
if applicable)
Tail
Item E
5
3B