Table of Contents
Advertisement
CL4490 User Guide
Version 3.0
Note:
The Laird Configuration Utility automatically programs the mode (point-to-point or point-to-
multipoint) based on the radio's current settings:
If the Destination Address field is set to a value other than FF FF FF FF FF FF, the radio sends data
only to the radio with the MAC specified in the Destination Address field (point-to-point).
If the Destination Address field is set to FF FF FF FF FF FF on a client radio, it is set to Auto
Destination mode, where the destination address is determined by the MAC address of the radio
from which the client received its last data packet (if both server and client have their Destination
Address field set to all FF, the client addresses all packets to the server only) (point-to-point).
If the Destination Address field is set to FF FF FF FF FF FF on a server radio, it is set to Broadcast
mode and transmits to all in-range clients with the same System ID and RF Channel as the server
(point-to-multipoint).
For more information on settings, see the Info Center in the Laird Configuration Utility or
download the
AC4490 Embedded Module User
Show Defaults
Note:
The
current factory default settings of the radio.
12. After all changes are made, select Write Radio to save the changes.
Quick Simple Setup
These steps are valid for both point-to-point and point-to-multipoint networks and are best
performed with units directly out of the box.
1. Connect and read first device.
2. Set this device as a server and set its Destination Address to FF FF FF FF FF FF; keep all
other factory default settings.
3. Connect and read next device.
4. Set this device as a client and set its Destination Address to FF FF FF FF FF FF; keep all
other factory default settings.
5. Repeat steps 3 and 4 for each additional device in the network.
TIP: If there are more than one networks within close range of each other, read the
procedure in
Americas: +1-800-492-2320 Option 2
Europe: +44-1628-858-940
Hong Kong: +852-2923-0610
www.lairdtech.com/ramp
button can display sample Radio settings. These settings
Appendix II: Sync to
Channel.
Manual.
14
do not
reflect the
Laird Technologies
Advertisement
Table of Contents
