Cisco Catalyst 3560CX Series Manual page 12

Hide thumbs Also See for Catalyst 3560CX Series:
Table of Contents

Advertisement

Enabling the Persistent MAC Address Feature
Step 6
Step 7
What to do next
To convert a stack port into a network port, run the no switch switch-number hstack-port stack-port command:
Switch(config)# no switch 1 hstack-port 1 TenGigabitEthernet 1/0/1
Switch# copy running-config startup-config
Switch# reload
Note
After configuration, restart the switch to convert the stack port into a network port.
Note
Stack port to network port conversion and vice versa cli is not nvgened. On write erase reload, the switch in
stack mode will not be converted to standalone, and manual conversion of stack port to network port is required.
Enabling the Persistent MAC Address Feature
Note
When you enter the command to configure this feature, a warning message appears with the consequences of
your configuration. You should use this feature cautiously. Using the old stack master MAC address elsewhere
in the same domain could result in lost traffic.
Follow these steps to enable persistent MAC address:
Managing Switch Stacks
12
Command or Action
Switch# show switch hstack-ports
copy running-config startup-config
Example:
Switch# copy running-config
startup-config
reload
Example:
Switch# reload
Managing Switch Stacks
Purpose
(Optional) Saves your entries in the
configuration file.
Reloads the configuration.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst ws-c3560cx-12pd-sCatalyst ws-c3560cx-8xpd-sCatalyst 3560-cxCatalyst 2960-cxWs-c3560cx-12pd-sWs-c3560cx-8xpd-s

Table of Contents