Whirlpool EVISOF Use And Care Manual page 4

Install properly...
* I2
3 inches
c
1 Check the strength of the floor. It should hold the
weight of a fully loaded freezer
2. Pick a safe place, indoors, away from in-
flammables such as gasoline.
3 Allow 3 Inches (7.5 cm) air space on top of freezer
for proper ventllatlon
4. Allow at least an Inch (2 5 cm] between the
freezer condenser, on the back of the unit. and
the wall
5. Allow % Inch (1 25 cm) on each side of the freezer
for ease of installation
6 If the freezer
IS
to be against a wall, you might
want to leave extra space on the hinge side so the
door can be opened wider
Level freezer...
so the door WI/I stay
open at any position
Raise -
lower
1. Keep the 4 bolts that hold refrigerator in shipping
crate. They are the levelling legs.
2. Screw these bolts all the way into bolt holes at the
bottom corners of refrigerator. Move refrigerator
into place.
3. Adjust each leg until the refrigerator won't rock.
4. Adjust front legs to level the refrigerator.
- To raise corners, turn legs in direction shown.
- To lower corners, turn legs in direction
shown.
5. Check with level.
4
Remove sales labels...
Remove the Consumer Buy Guide label and any
lnslde labels before using the freezer.
To remove any remaining glue:
1. Rub briskly with thumb to make a ball, then
remove
OR
2 Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water] be-
fore removing glue as described in step 1
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE the Tech Sheet fas-
tened under the freezer at the front.
Clean it . . .
Clean your freezer before
using it See cleaning
instructions on page 7
Plug it in...
3-prong gro
type wall ret
Retaining Clip
' ' " grounding plug
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided. Use a
receptacle which cannot be turned off with a
switch or pull chain. Do not use an extenslon
cord.
Attach retaining clip over power cord plug
from literature package inside the freezer.