Outdoor Essentials Picnic Table 9334 Assembly Instructions

• 1 – Preassembled table top (A)
• 2 – Preassembled seats (B)
• 2 – Predrilled seat crossmembers (C)
• 2 – 24" diagonal braces (D)
• 4 – Predrilled table legs (E)
• 20 – 2-1/2" carriage bolts, washers and wing nuts
• 4 – 1-3/4" wood screws
Items you will need
• Drill or screwdriver with a Phillips head bit
• Adjustable wrench
To maintain the appearance of your table, seal with a finishing oil
every year.
Insert four (4) 2-½" carriage bolts into the predrilled seat
crossmember (C) and position so that the bolt heads are on the
ground and the threads are exposed. Be sure to position the
seat crossmember so its outer predrilled holes will be at the top
of the finished assembly. These will be used when assembling
the seat support. Position the legs (E) so that the predrilled
holes align with the bolts and the tops of the legs are level
and straight. Add the washers and secure with the wing nuts.
Repeat step for the second leg assembly (fig. 1).
Place the preassembled table top (A) upside down and position
the legs as shown, making sure the seat crossmember is facing
out. Attach the legs to the table top using four (4) 2-½" carriage
bolts through the predrilled holes and secure with washers and
wing nuts (fig. 2). Repeat step for the second leg assembly.
Once the leg assemblies are attached, tighten carriage bolts
with a wrench.
©2017 Universal Forest Products, Inc. Outdoor Essentials is a registered trademark of Universal Forest Products, Inc.
Contents
Optional
Step 1
Step 2
Assembled in the USA with imported fasteners. All rights reserved.
2801 East Beltline NE, Grand Rapids, MI 49525 800.598.9663 9334_4/17
OutdoorEssentialProducts.com
6-FT RED BALAU PICNIC TABLE
ASSEMBLY INSTRUCTIONS
C
(4) 2-1/2" carriage
bolts through
crossmember
and legs
A
D
E
B
Predrilled holes
(4) 2-1/2"
carriage bolts
fig. 1
fig. 2