Advertisement
PICNIC TABLE ASSEMBLY INSTRUCTIONS, CONT.
Position and attach a predrilled diagonal brace (D) between the
seat crossmember and the center table support using the 1-¾"
wood screws. Before attaching the diagonal brace, make sure
the legs are perpendicular to the table top. This will ensure that
the table top is level and the seats can be attached correctly
(fig. 3). Repeat step for the second leg assembly. Turn the table
right side up.
Place the outside edge of the seat support (B) flush with the end
of the seat crossmember. Align the predrilled hole in the seat
crossmember with the predrilled hole in the seat support. Insert
the carriage bolt and secure it using a washer and wing nut (fig. 4).
Repeat step for both ends of each bench.
Ensure all wing nuts and screws are fully tightened.
THE DIAGRAMS AND INSTRUCTIONS IN THIS BROCHURE ARE FOR ILLUSTRATION PURPOSES ONLY AND ARE NOT MEANT TO REPLACE A LICENSED PROFESSIONAL. ANY CONSTRUCTION OR USE OF
THE PRODUCT MUST BE IN ACCORDANCE WITH ALL LOCAL ZONING AND/OR BUILDING CODES. THE CONSUMER ASSUMES ALL RISKS AND LIABILITY ASSOCIATED WITH THE CONSTRUCTION OR USE
OF THIS PRODUCT. THE CONSUMER OR CONTRACTOR SHOULD TAKE ALL NECESSARY STEPS TO ENSURE THE SAFETY OF EVERYONE INVOLVED IN THE PROJECT, INCLUDING, BUT NOT LIMITED TO,
WEARING THE APPROPRIATE SAFETY EQUIPMENT. EXCEPT AS CONTAINED IN THE WRITTEN LIMITED WARRANTY, THE WARRANTOR DOES NOT PROVIDE ANY OTHER WARRANTY, EITHER EXPRESS
OR IMPLIED, AND SHALL NOT BE LIABLE FOR ANY DAMAGES, INCLUDING CONSEQUENTIAL DAMAGES.
©2017 Universal Forest Products, Inc. Outdoor Essentials is a registered trademark of Universal Forest Products, Inc.
Step 3
Step 4
Step 5
Assembled in the USA with imported fasteners. All rights reserved.
2801 East Beltline NE, Grand Rapids, MI 49525 800.598.9663 9334_4/17
OutdoorEssentialProducts.com
1-3/4" wood
screws
2-1/2"
carriage bolts
through seat to the
seat crossmember
fig. 3
fig. 4
Advertisement
