Fitting The Truck Mounted Charger System - MSA EVOLUTION 6000 Series Operating Manual

Fitting the Truck Mounted Charger System

2 Fitting the Truck Mounted Charger System
The truck mounted charger system is mounted in the vehicle using the vehicle installation kit.
For installation, a sufficiently large flat surface is required which:
guarantees comfortable access to the camera
-
does not require a cable longer than 10 feet (3 meters) to the power source and
-
protects the charging system from water spray and extreme temperatures.
-
Installation Kit
Fig. 1 Installation kit
1 Suspension rails
2 Anti-vibration mounting washers
Necessary Tools and Material
Installation kit for truck charger system
-
Power drill and metal drill bits [#7 (0.201) or 5 mm and 9/32 (0.281) or 7 mm]
-
Thread tap 1/4-20 or M6
-
Phillips screwdriver with long shank
-
4 stainless steel 3/4-20 bolts or M 6 x 25 bolts
-
5 Amp fuse
-
ON / OFF circuit breaker
-
Strain relief bushing for power supply cable
-
6
4
EVOLUTION 6000 series Truck Mounted Charger
1
2
3
3 Screws
4 Spring nuts
MSA
US