Advertisement
5
PIECES
P4
× 56
Rt
Re
Rp
Rp
Rt
465 — 05 / 20 — A4.10
bEGIN WITH THE CHICKEN RUN END:
Lay panels 2 & 3 in position. Align the
wood pegs along the roof lines with the
P5
guide holes on the panel undersides. If
dowels and guide holes don't properly
align, gently adjust the coop frame until
alignment is achieved.
Lay center panels
× 36
DO NOT ATTACH PANELS. Check the
roof panel alignment. Adjust the coop
frame as necessary to get as straight
an alignment as possible.
A jagged, uneven, stair-stepped alignment along the roof
panels means the coop frame is not aligned. Shift the coop
frame right or left to get a clean alignment edge.
COOP HOUSE END:
Place panels over the Coop House end,
using the same method: outer-edge
panels first, then center panels.
Recheck the alignment and adjust as
necessary.
With roof panels aligned, starting with
the center panels/middle seam, begin
attaching the roof to the frame.
P4
Attach with [P4] screws.
ROOF END CAP TRIM:
Re
Attach the two middle [ ]
end trim first.
Align the outer-edge (2 & 3)
trim off of the middle pieces.
Attach end cap
P4
trim with [P4] screws.
PREP: Lay the roof seam trim
in position FIRST and adjust for
the cleanest alignment.
trim slats are positioned
along the peak.
2 trim slats are positioned
over the side seams.
Start with the peak
P5
trim/middle seam and
work out to the ends.
Attach with [P5] screws.
For more wonderful cages, toys, and accessories for cats, birds, chickens, rabbits, ferrets, dogs and small animals, visit www.prevuepet.com
2
&
in position.
INCORRECT ALIGNMENT
2
1
2
3
3
CORRECT ALIGNMENT
1
3
1
2
1
3
3
1
1
2
3
2
Assembly completed.
2
1
2
1
1
2
3
Advertisement
