Starting Your Dishwasher - Whirlpool DU7903XL Use & Care Manual

Clean Slgnal light
/ Option Selebor Buttons
Clean Selector Buttons
Starting your dishwasher
1. Push a Clean Selector Button for the
desired cycle.
2. With the Cycle Control Knob pushed
in, turn it to point at the desired cycle -
you will feel a definite stop at each
cycle mark.
-POTS & PANS and HEAVY WASH
Cycles share the same spot on the
dial. The Clean Selector Button de-
termines which cycle operates.
3. Push Option Selector Button for de-
sired option or options. (Use AIR DRY
for RINSE & HOLD Cycle.)
4. Pull out the Cycle Control Knob to start
the cycle.
The AIR DRY Option
Air in the dishwasher is automatically heated
during the "dry" part of all cycles.
If the AIR DRY Optlon is selected, air in the
dishwasher is not heated. Using this option helps
save energy, but dishes take longer to dry (over-
night) and some water spotting may result.
Some items [such OS plastics) may need towel
drying.
Open the door long enough for steam to
escape. Close the door to allow the Cycle
Control Knob to complete its cycle.
HI-TEMP WASHING Option
If water is already hot enough, the cycle
When this option is selected, water for the
continues without delay. The WATER HEATING
main wash and the final rinse is heated -
HOLD Signal Light will be on while the cycle
except in RINSE HOLD Cycle-to 145°F (63°C).
delays for water heating.
Changing a setting
You can change o setting anytime during
any cycle.
2. Turn the Cycle Control Knob clockwise to
the cycle you wont.
3. Be sure detergent dispensers ore filled
properly for the new cycle.
1. Push in the Cycle Control Knob to stop the 4. Pull out the Cycle Control Knob to start the
cycle.
cycle.
To add a dish after starting
4. Close the door. Do not latch It. Wait 30 sec-
1. To be sure the added item is washed and
rinsed, make sure the Cycle Control Knob
onds for air in the dishwasher to worm up.
This helps reduce the amount of moisture
has not passed LOW ENERGY WASH.
that con come from the vent when restort-
2. Unlatch the door to stop the cycle, but don't ing the cycle.
open it until the spray arms stop spinning. 5. Latch the door. The dishwasher will start
3. Open the door and odd the dish.
from where it stopped.
The CLEAN Signal Light
To turn it off. Turn the Control Knob clockwise
The CLEAN Signal Light will come on when a slightly until the light goes off. Do not pull out
washing cycle is complete.
the Control Knob.