Cisco UCS 6400 Series Hardware Installation Manual page 41

Replacing Components
Example:
FI-A# show cluster extended-state
Cluster Id: 0x537d0580bf9911e0-0x8955000decd07984
A: UP, PRIMARY
B: DOWN, INAPPLICABLE
A: memb state UP, lead state PRIMARY, mgmt services state: UP
B: memb state DOWN, lead state INAPPLICABLE, mgmt services state: DOWN
heartbeat state SECONDARY_FAILED
INTERNAL NETWORK INTERFACES:
eth1, DOWN
eth2, DOWN
HA NOT READY
Peer Fabric Interconnect is down
Detailed state of the device selected for HA storage:
Chassis 1, serial: FOX1344G1R1, state: active
Chassis 2, serial: FOX1318GDKR, state: active
FI-A#
Step 7 Remove the fabric interconnect from the rack. Follow the instructions in
Interconnect From a Rack, on page
Step 8 Install the replacement fabric interconnect to the rack. Follow the instructions in
in a Cabinet or Rack, on page
Step 9 Connect the management and console cables to the replacement fabric interconnect.
Step 10
Connect the L1/L2 cables that were disconnected to the replacement fabric interconnect.
Step 11 Connect the data cable according to the labels that you created in Step 2.
Step 12
Connect the power cable to the fabric interconnect and it will automatically boot and run POST tests.
This setup utility will guide you through the basic configuration of
the system. Only minimal configuration including IP connectivity to
the Fabric interconnect and its clustering mode is performed through these steps.
Type Ctrl-C at any time to abort configuration and reboot system.
To back track or make modifications to already entered values,
complete input till end of section and answer no when prompted
to apply configuration.
Enter the configuration method. (console/gui) ? console
Installer has detected the presence of a peer Fabric interconnect.
This Fabric interconnect will be added to the cluster. Continue (y/n) ? y
Enter the admin password of the peer Fabric interconnect:
Connecting to peer Fabric interconnect... done
Retrieving config from peer Fabric interconnect... done
Peer Fabric interconnect Mgmt0 IP Address: 122.255.252.2
Peer Fabric interconnect Mgmt0 IP Netmask: 255.255.255.0
Cluster IP address
Physical Switch Mgmt0 IPv4 address : 122.255.252.3
Apply and save the configuration (select 'no' if you want to re-enter)? (yes/no): yes
Applying configuration. Please wait.
37.
18.
---- Basic System Configuration Dialog ----
: 122.255.252.1
Cisco UCS 6400 Series Fabric Interconnect Hardware Installation Guide
Shutting Down a Fabric Interconnect
Removing a Cisco UCS Fabric
Installing the Cisco UCS FI
35