Advertisement
Environmental Notices
The equipment covered by this manual must be disposed of or recycled in accordance
with the Waste Electrical and Electronic Equipment Directive (WEEE Directive) of the
European Community directive 2012/19/EU on waste electrical and electronic equipment
(WEEE) which, together with the RoHS Directive 2015/863/EU, for electrical and
electronic equipment sold in the EU after July 2019. Such disposal must follow national
legislation for IT and Telecommunication equipment in accordance with the WEEE
directive: (a) Do not dispose waste equipment with unsorted municipal and household
waste. (b) Collect equipment waste separately. (c) Return equipment using collection
method agreed with Omnitron.
The equipment is marked with the WEEE symbol shown to indicate that it must
be collected separately from other types of waste. In case of small items the
symbol may be printed only on the packaging or in the user manual. If you have
questions regarding the correct disposal of equipment go to www.omniton-
systems.com/support or e-mail to Omnitron at intlinfo@omnitron-systems.com.
Safety Warnings and Cautions
ATTENTION: Observe precautions for handling electrostatic discharge sensitive
devices.
WARNING: Potential damage to equipment and personal injury.
WARNING: Risk of electrical shock.
Customer Service Information
If you encounter problems while installing this product, contact Omnitron Technical
Support:
Phone:
(949) 250-6510
Fax:
(949) 250-6514
Address:
Omnitron Systems Technology, Inc.
38 Tesla
Irvine, CA 92618, USA
Email:
support@omnitron-systems.com
URL:
www.omnitron-systems.com
Page 3
Product Overview
The front panel of the XM5 provides access to the RJ-45 (fixed copper) and SFP/SFP+/
XFP ports. The back panel of the XM5 provides access to the management (serial
console and Ethernet) port, alarm contact connector, clock I/O connectors, reset button
and power connectors. All available hardware options are shown.
Front Panel Layout
Rear Panel Layout with Dual AC Barrel Connectors
Serial Console Port
The XM5 features a RS-232 Serial Console Port (aka Craft Interface) which can be
connected to a computer for initial setup and configuration. The Serial Console Port is
accessed through the a RJ-45 port on the back of the module.
Ethernet Management Port
The XM5 supports a 10/100/1000Mbps Ethernet management port. The port supports
auto-negotiation and auto MDI/MDI-X crossover. The physical port is referred to as
Port 8 in the CLI menus.
Page 4
Advertisement
