Before Starting Your Dishwasher; Starting Your Dishwasher; Changing A Setting; To Add A Dish After Starting - Whirlpool DP4800XS Use & Care Manual

Before starting
c
your dishwasher
1.
Spin the Upper Spray Arm to make sure
nothing will stop it from turning freely.
2. Close and latch the door.
3. Run hot water at sink nearest dishwasher
until it is hot. Turn it off. (See page 14 for
connecting instructions.)
CLEAN SELECTOR BUTTONS
Starting your dishwasher
POTS 81 PANS Cycle...
HEAVY WASH Cycle...
1.
Make sure Cycle Control Knob points 1.
Make sure Cycle Control Knob points
to dot marked POTS & PANS.
to dot marked HEAVY WASH..
2. Push POTS & PANS Clean Selector
2. Push HEAVY WASH button.
Button. 3. Push button for option desired.
3. Push button for option desired.
4. Without turning it, pull out the Cycle
4. Without turning it, pull out the Cycle
Control Knob to start the cycle.
Control Knob to start the cycle.
NORMAL WASH Cycle...
RINSE & HOLD Cycle...
1.
Turn Cycle Control Knob clockwise until
1. Push NORMAL WASH button.
it stops at dot marked NORMAL WASH.
2. Select AIR DRY OPTION
only. Do not use
2. Push NORMAL WASH button. HI-TEMP WASHING Option.
3. Push button for option desired.
3. Turn Cycle Control Knob clockwise to
4. Without turning it, pull out the Cycle Con-
dot marked RINSE & HOLD.
troi Knob to start the cycle.
4. Close and latch the door to start the
cycle.
Changing a setting
2. With the Cycle Control Knob pulled out,
You can change a setting anytime during
turn clockwise to the cycle you want.
any cycle.
3. Be sure the detergent dispensers are filled
1. Unlatch the door to stop the cycle, but don't
properly for the new cycle.
open it until the spray arms stop spinning.
4. Latch the door to start the cycle.
To add a dish after starting
4. Close the door. Do not latch it. Wait 30 sec-
onds for air in the dishwasher to warm UD.
1. To be sure the added item is washed and
This helps reduce the amount of moisture
rinsed, make sure the Cycle Control Knob
that can come from the vent when restart-
has not passed NORMAL WASH.
ing the cycle.
2. Unlatch the doorto stop the cycle.
5. Latch the door. The dishwasher will start
3. Open the door and add the dish.
from where it stopped.
HI-TEMP WASHING Option
When this option is selected, water for the
main wash and the final rinse is heated [except
in RINSE & HOLD) to 145'F (63-C). Washing and
rinsing action in those parts of the cycle will
be longer if the water is heated. HI-TEMP wash-
ing is automatic in POTS & PANS.
8