Whirlpool AD65USM2 Use And Care Manual page 6

1187730ENv10 12/3/03 1:11 PM Page 6
6
Setting the Controls
Control C
Minimum operating
temperature is 44°F (7°C)
selects mode
If your control looks like C:
To turn dehumidifier on
Press the ON/OFF button. If the
Empty/Adjust Bucket light comes on, the
dehumidifier will not operate. Empty or
adjust bucket.
Each time you unplug the dehumidifier
or power is interrupted, the control will
return to your previous settings.
To turn dehumidifier off
Press the ON/OFF button.The
dehumidifier will retain your last
settings.
Empty/Adjust bucket light
If this light is on, the dehumidifier is not
running.This light indicates that you
need to check:
• If the bucket is full, empty bucket and
replace.
• If the bucket is not in position, remove
bucket and replace. Make sure the
bucket fits all the way into the
dehumidifier and the light is off, or
dehumidifier will not run.
Mode selection
Press MODE button to select fan speed.
Choose LOW, HIGH, CONTINUOUS or
AUTO DRY. High speed will give a faster
response time to reach the humidity set
point. Low speed will give a slower
Dehumidifier Use (cont.)
DRY
AUTO DRY
CONTINUOUS
MOIST
HIGH
LOW
ON / OFF
MODE
response time to reach the humidity set
point, but at a lower sound level.
If you have selected LOW or HIGH:
Press
moisture you want removed. Pressing
removed; pressing
amount of moisture removed.The
indicator light will change according to
the number of times you press
If you have selected CONTINUOUS:
You cannot select the amount of
moisture you want removed. In
Continuous mode, the dehumidifier will
run continuously regardless of the
humidity level.
The dehumidifier will shut off only if the
bucket is full or removed.
NOTE: The Deicer will turn the
compressor off if a low temperature
condition exists. Pressing
not increase or decrease the amount of
moisture removed.
If you have selected AUTO DRY:
Press
moisture you want removed. AUTO DRY
provides the best humidity control of all
the modes by automatically adjusting
the fan speed and/or turning the
dehumidifier on and off to maintain your
settings.
indicates the bucket is full
OR
the bucket is not in position
EMPTY /ADJUST
BUCKET
adjusts humidity removal set point
(amount of moisture removed from room)
or to set the amount of
increases the amount of moisture
decreases the
or to set the amount of
or .
or will