R3S User Manual
Connecting the Devices
The system comes with a controller to ensure that the device is well-shielded against premature failure at
the boot or shutdown phase. When installing:
1. Make sure both your vehicle and the system are turned off.
2. Follow the wiring definition and illustration below to connect the vehicle battery and ignition (ACC) to
the in-vehicle system through the 5-pin M12 male connector marked as "DC Input" on the system,
through the right pin contact.
In a typical in-vehicle computing solution, this system usually acts as a PSE (Power Sourcing Equipment) to
power up connected PoE devices, for which you should ensure a minimum of 48V DC power supply to the
system with the use of a DC to DC Adapter.
Negative
Positive
BATTERY
Chassis Ground
Pin1
Pin2
Pin3
Pin4
PE
DC Input
(System)
Ignition in
Ground
VCC
GND_DCIN
Ignition
Chassis Ground
54