Back To Work Position; Boom Lift & Platform Tilt Without Outriggers; Ending Operation - Leguan 135 NEO Operator's And Service Manual

Back to work position

Back to work position-function is activated by turning the Back to work position/Home-switch
(figure 7, switch 7) counter clockwise to Back to work position-position and holding it there
while using the function. When using the function boom will move automatically to position
from where Home-function where activated last time after using the joystick.
When Back to work position-function is ready audible signal is given. Pay attention to
surroundings when using this function. Be aware that Home and Back to works position
movement paths are not necessary the same.
Boom Lift & Platform Tilt Without Outriggers
The boom can be raised slightly (approx. 10 cm) to avoid hitting the platform on an obstacle
when driving in difficult terrain. Lifting the boom can be done by pressing the lowering button
down (page 16, Figure 1, button 1) and simultaneously tilting the joystick forwards.
Also, the platform tilt can be used without outriggers in a similar fashion. To activate the
platform tilt without outriggers: press the platform tilt button (figure 1, 5) simultaneously while
tilting the joystick forwards to raise platform or backwards to lower it.
Boom can be operated without outriggers from lower controls also. Function is similar than on
using the upper controls.

Ending operation

After concluding operation:
1. Lower the booms down to transport position.
2. Lift the outriggers completely up to transport position.
3. Turn the ignition key to the '0' position and take it with you.
4. Remove safety harnesses from the platform and take them with you (harnesses must be
kept in their place and in their box/package).
5. Close the fuel faucet (see the engine manufacturer's manual).
6. If the machine stays in a place where it can be connected to 230 VAC mains current, it is
recommended to leave it connected to charge the battery (e.g., overnight). The battery
charges even when the main power switch is not engaged.
NOTE! Prevent unauthorised use of the access platform!
29