Table of Contents
Advertisement
Operating the tool (8)
1. Timely press tacker head D against the workpiece until it is pushed in a few milimeters
2. Press trigger E and then release it again
3. Switch F is locked as long as you do not press tacker head D against the workpiece, thus
preventing accidental operation
4. At 20 shots/min., tacker should be allowed to cool down after 30 minutes as it is only rated for
short-time duty
Remove all staples/nails from the magazine after each use !
Impact control (9)
1. With wheel G the required impact level can be selected in steps
2. Indicator F shows the selected impact level
3. "-" for thin and light materials such as foils and fabrics
4. "+" for thick and tough materials such as hard woods and similar materials
5. Before starting, find the optimal impact level by testing out on spare material
APPLICATION ADVICE
Fastening panels (10)
Do not use the tool for fastening ceiling panelling on profiled wood or grooves
Fixing textiles (11)
Avoid blank shots in order to reduce the wear of the impact strike
Keep tool and charger clean
Unplug charger from power source before cleaning !
WilTec will cannot be held responsible for any damage caused by normal wear and tear,
overload or improper handling.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Seite 16
Advertisement
Table of Contents
