Safety Instructions For Tackers - WilTec 61859 Operation Manual

conditions and the work to be performed. Use of the power tool for operations different from those
intended could result in a hazardous situation.
5) SERVICE
a) Have your power tool serviced by a qualified repair person using only identical replacement
parts. This will ensure that the safety of the power tool is maintained.

SAFETY INSTRUCTIONS FOR TACKERS

 Secure the workpiece (a workpiece clamped with clamping devices or in a vice is held more
securely than by hand)
 Never push in the tacker head manually (4) (there is danger of injury when at the same time
the trigger is activated unintentionally)
 Never use the tool for fastening electrical wiring (contact with electrical wires can lead to
fire and electric shock)
 Avoid damage that can be caused by screws, nails and other elements in your workpiece;
remove them before you start working
 Always check that the supply voltage is the same as the voltage indicated on the identification
plate of the tacker (tackers with a rating of 230V or 240V can also be connected to a 220V
supply)
 In case of electrical or mechanical malfunction, immediately switch off the tool or unplug
charger from power source
 We can assure flawless functioning of the tool only when original accessories are used
 This tool should not be used by people under the age of 16 years
 Do not expose tool to rain. (5)
USE
Loading staples/nails (6)
1. Turn tool upside down
2. Press lever A while pulling slider B backwards
3. Insert the staple/nail strip into magazine C with the staple points facing up (max. capacity 100
staples)
4. Push the slider B against tacker head D until it locks
5.
When inserting a nail strip (not suplied with the tool) tilt the tool in such a way, that the nail
strip rests Against the magazine side which corresponds with the nail symbol in tacker head D
(7)
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Seite 15