Table of Contents
Advertisement
STEP 4
IMPORTANT: Tighten all bolts
AT THIS POINT, ALL BOLTS SHOULD BE
TIGHTENED. TIGHTEN BOLTS OPPOSITE
EACH OTHER RATHER THAN TIGHTENING
ALL BOLTS ON ONE SIDE FIRST SO THAT THE
CART REMAINS ALIGNED. AvOID USING
ExCESSIvE FORCE WHEN TIGHTENING
BOLTS. OvER-TIGHTENING BOLTS CAN MAKE
DRAWERS BIND AND HINDER OPERATION.
STEP 5
Attach handles to drawer faces
Open the bottom drawer of the service
cart. Align the end of the long handle
with the edges of the bottom drawer,
so that the channel in the handle covers
all four holes in the front of the drawer.
Insert screws through each hole from
inside the drawer and into the drawer
handle channel. Tighten the screws.
Repeat for all remaining drawers using
short handles.
NOTE: DO NOT ALLOW HANDLES TO OvER
HANG THE ENDS OF THE DRAWER
FACES, AS THEY WILL INTERFERE WITH
THE OPERATION OF THE DRAWER.
A S S E M B LY
STEP 6
Attach casters
With the provided keys, lock all drawers,
the top and the pry bar holder to prevent
them from opening. Turn the cart upside
down, allowing it to rest on chrome leg
tops with the plastic inserts facing up.
NOTE: DO NOT ALLOW THE SIDE WORK BENCH
TO SWING FREELY, AS IT MAY BE
DAMAGED OR CAUSE INjURY AS CART
IS TURNED UPSIDE DOWN.
Insert the stem of one caster into the hole
in a plastic insert. Using a rubber mallet,
hammer the casters into place until the
stem is no longer visible. Repeat with
other casters.
NOTE: MAKE SURE BOTH LOCKING CASTERS
ARE EITHER ON THE RIGHT HAND SIDE
OR LEFT HAND SIDE OF THE CART.
Once all casters are installed, stand the
cart upright. Assembly is complete.
5
Advertisement
Table of Contents
