Assembly Preparation - OEM Tools 24962 Manual

NOTE: DO NOT FULLY TIGHTEN FASTENERS
UNTIL PROMPTED.
STEP 1:

Assembly preparation

Clear table top and set locking drawer
assembly on table top, with lid facing up.
Position the locking drawer assembly
so that one end hangs off the table
enough to allow the chrome legs to go
through the square holes. Insert one set
of chrome legs through the overlapping
holes as shown in Figure 1. Do not bolt
legs to top.
Locking Drawer
Assembly
Chrome
Legs
Table or
workbench
STEP 2:
Connect legs and side
accessory to drawer assembly
Choose one of the side accessories (pry
bar holder or side work bench – Figure 2
shows pry bar holder) for attachment to
the overhanging end of the service cart.
Align the outermost bolt holes in the
accessory with the bolt holes in the end
of the cart and with the uppermost holes
in the chrome legs. Position a washer and
insert a 10 mm bolt through the washer,
bolt holes and legs as shown. Secure
bolts with a flat washer, lock washer and
nut on inside of locking drawer assembly.
A S S E M B LY
Tighten bolts until parts fit
together firmly.
REPEAT STEPS 1 AND 2 FOR OTHER END OF
CART, USING REMAINING SIDE ACCESSORY.
Locking Drawer
Assembly
Table or
workbench
STEP 3:
Connect the bottom
Locking top
tray to the chrome legs
Lift the cart and place on top of the
bottom tray with chrome legs through
the square leg-holes. Align bolt holes in
bottom tray with lower holes in legs and
insert a 10 mm bolt through the washer,
bolt holes and legs as shown. Repeat
with all remaining holes in bottom tray.
4
Chrome
Legs
Bottom
Tray
Chrome
Legs
Locking top
M6 x 40
Bolt
Pry Bar
Holder
M6x40
Bolts