Storage And Transport; Troubleshooting; Warranty - ADE VITALIS Series Operating Manual

During transport and storage, the ambient temperature must be between -25°C and +55°C with a maximum
value of +70°C (provided that the exposure time does not exceed 24 hours).
Keep all parts of the packaging in case you need to return the shipment to avoid possible damage during
transportation.
The information below is intended to help you identify and remedy any faults or malfunctions that may occur
during operation. Some faults may be remedied by the operator, others require precise technical competence
or special skills and may only be remedied by qualified staff, who has proven and recognised experience.
Do not remove any internal parts of the device. The manufacturer assumes no liability for
damage caused by manipulations.
Malfunctions
Fault
The device does not start.
The device does not start.
The device does not start.
The device does not start.
The device does not start.
The direction of rotation of the tool
is not correct.
ADE will repair or replace this product if it has failed within 1 year from the date of purchase (proof of purchase
is required) due to poor workmanship or defective material.
The above does not apply to all moving parts such as a power cord, collecting pot, pusher, discs, etc. Warranty
does not apply to normal appearance of usage or sign of wear or any damages caused by accidents or misuse.
The warranty will not apply for devices that have been opened by unauthorised persons.
This warranty agreement does not affect the customer's legal rights in any manner.
The dealer from whom the machine was purchased is responsible for complaints.

STORAGE AND TRANSPORT

TROUBLESHOOTING

Causes
The main switch is off.
No voltage on the power supply
line.
The retaining device has not been
pushed down.
The collecting pot has not been
inserted correctly.
The fuse has blown.
The current phases of the power
cord of the device are not
connected correctly.

WARRANTY

Remedy
Turn on the main switch.
Contact your dealer or the
customer service.
Push down the retaining device.
Make sure that the collecting pot
is inserted correctly.
Contact your dealer or the
customer service.
Have the current phases of the
power cord swapped by a
qualified technician.