USA Technologies ePort G9 Card Reader Install Manual page 5

10. Align the four set-screws in the back of the card
reader to the 3/16th inch holes, and mount the
card reader to the front panel of the system with
the four supplied nuts (FIG. 6). It may be nec-
essary to use the large fl at washers to catch the
sides of the front panel (FIG. 7).
11. Mount and attach the G9 Telemeter inside the
Ovation as shown in FIG. 8 with the other half of
the supplied black velcro strips.
12. Route antenna cable through the back of the
upper portion of the system. The antenna has
a magnetic base that will secure it to any metal
surface. If there is no metal surface within reach, use the Velcro buttons supplied to mount to any surface.
MOUNTING THE EPORT G9 CARD READER IN A PLAYDIUM MACHINE
1. Remove power from the system.
2. Remove the 2 backlight connectors for the credit
card reader shown by the arrows in FIG. 9. Po-
sition the wires out of the way so they are not
damaged when drilling.
3. Place the supplied self-adhering drill template on
the outside of the system so that the cross-hair of
the large drill hole in the center of the template is
centered over the middle of the card reader slot
of the front panel (FIG. 10).
4. Using a 3/16th inch drill bit, drill the 4 mounting
holes, and a pilot hole for the larger hole in the
middle.
5. Using a ½ inch drill bit, drill the piloted large hole
through the plastic credit card slot in the panel.
The drill should exit directly below the existing
card reader mounted on the inside. See the
arrow in FIG. 11.
6. Pass the black connector of the card reader
through the ½ inch drilled hole.
7. Align the four set-screws in the back of the card
reader to the 3/16th inch holes, and mount the
card reader to the front panel of the system with
the four supplied nuts.
8. Mount the G9 Telemeter inside the Playdium as shown in FIG. 12 with other half of the supplied black Velcro strips.
9. Route antenna cable through the back of the upper portion of the system. Remove the lower right strain relief, and
bring antenna wire up alongside the Playdium. The antenna has a magnetic base that will secure it to any metal
surface. If there is no metal surface within reach, use the Velcro buttons supplied to mount to any surface.
10. Reconnect backlight connectors that were removed in step 2.
FIG. 7
FIG. 4
FIG. 6
FIG. 10
4
FIG. 5
FIG. 8
FIG. 9
FIG. 11 FIG. 12