Studiomaster Professional AQUA Series Instruction Manual page 6

41. Level: The LED level meter on the effects module displays the level fed to the effects processor. Take care to ensure that the clip
LED only lights up at peak levels. If it is lit constantly, you are overloading the effects processor and this could cause unpleasant
distortion. The EFX SEND knob determines the level that reaches the effects module.
42. 24-BIT EFX PROCESSOR: Here you can find a list of all presets stored in the multi-effects processor. This built-in effects module
produces high quality standard effects such as reverb, chorus, flanger, delay and various combination effects.
These effects presets are designed to be added to dry signals. A signal has to be fed into the effects processor via the EFX send
knob in each channel.
The overall EFX send level can be adjusted via EFX SEND knob located below the effects processor module. The level of the effect
processor output can be adjusted via EFX MIX fader, which can be routed to Main and Group outputs.
The effects processor has 16 types of effects in total. Each effects type has two layers of adjustable sub-parameters. These functions
are controlled by the PROGRAM encoder and TAP switch.
Available Effects:
Effect No.
1
2
3
4
5
6
7
8
43. PROGRAM: This rotary encoder is used to select the effect preset.
Turn the control encoder to select the desired effect preset number. The display flashes as you scroll through the presets
PROGRAM
menu.
To confirm the selected preset, press down on the
been confirm.
When the effect type is selected, press down on the encoder to enter the first layer of parameters. The decimal point on the lower
right corner of the display will light up to show that you are in the first layer parameter interface. By turning the encoder at this time,
you can promptly change the selected effect specific parameters. The adjustments made will be immediately reflected in the sound
performance.
44. Tap Switch:
• Tap switch is used to select time interval parameter and no. of repetitions.
• Please follow the steps to use Tap function.
Step 1: Rotate program control to select Effect from list as a printed on panel. The display will show the selected effect no.
from 1 to 16.
Step 2: Press Tap switch to select & change Time Interval parameter. The display will show number with decimal point on
lower right corner.
Effect Name
Hall
Room
Plate
Gated
Reverse
Early Ref
Ambience
Delay
PROGRAM
Effect No. Effect Name
9 Echo
10 Chorus
Flanger
11
12 Phaser
13 Detune
14 Pitch + Shifter
Delay + Rev
15
16 Chorus + Rev
knob. The flashing stops to show that the selected effect type has
.
4