Table of Contents
Advertisement
Installing HBAs in the Server
Before You Start
Install HBAs
AX100-Series - Installing a Fibre Channel Storage System with a Switch Connection to a Windows Server
For the server to communicate with the storage system through the
Fibre Channel ports, the server must have one or more supported
Fibre Channel host bus adapters (HBAs). If the HBAs are already
installed, go to
this section for all other configurations.
To complete this procedure, you need one or more supported QLogic
or Emulex Fibre Channel HBAs with the latest supported BIOS and
driver. For information on supported HBAs, BIOS, and drivers, refer
to Supported Configurations in the "Technical descriptions" section on
the AX100 support website. Never mix Fibre Channel HBAs from
different vendors in the same server.
CAUTION
!
HBAs are very susceptible to damage caused by static discharge
and need to be handled accordingly. Before handling HBAs,
observe the following precautions:
•
Store HBAs in anti-static bags.
•
Use a ground (ESD) strap whenever you handle HBAs.
•
Never plug or unplug HBAs with the power on. Severe
component damage can result.
1. If the server is running, shut it down as follows:
a. Shut down the server's operating system.
b. Power down the server.
c. Unplug the server power cord from the power outlet.
2. Remove the outer covers from the server so that you can access
the PCI bus slots.
For information on how to remove the covers from the server,
refer to the installation documentation supplied with the server.
Installing or Updating the HBA Driver
Installing HBAs in the Server
(page
9).
Read
7
Advertisement
Table of Contents
