Table of Contents
Advertisement
ToolS AnD PARTS
Gather the required tools and parts before starting installation.
Tools needed:
Flat-blade screwdriver
Wire stripper (direct wire
installations)
1/4" and 5/16" nut driver
(recommended)
Utility knife
Level
Caulking gun and
compound (for installing
new exhaust vent)
® TORX is a registered trademark of Saturn Fasteners, Inc.
INSTALLATION REQUIREMENTS
#2 Phillips screwdriver
Tin snips (new vent
installations)
Adjustable wrench that
opens to 1" (25mm) or
hex-head socket wrench
Tape measure
Pliers
Min. 8" long Torx
T25
®
screwdriver
(for door reversal only)
Parts needed:
(Not supplied with dryer)
Vent clamps
■
Vent elbows and ductwork
■
Additional parts may be required, depending in your installation.
Check local codes. Check existing electrical supply and venting.
Read "Electrical Requirements" and "Venting Requirements"
before purchasing parts.
If using a power supply cord:
Use a UL listed power supply cord kit marked for use with
clothes dryers. The kit should contain:
A UL listed 30-amp power supply cord, rated 120/240 volt
■
minimum. The cord should be type SRD or SRDT and be
at least 4 ft. (1.22 m) long. The wires that connect to
the dryer must end in ring terminals or spade terminals
with upturned ends.
A UL listed strain relief.
■
Parts supplied:
Parts package is located in dryer drum. Check that all parts
are included.
noTE: Do not use leveling legs supplied if installing with a
pedestal or a stack kit.
Leveling legs (4)
Short inlet hose
Rubber washer
optional Equipment:
(Not supplied with dryer)
Refer to your Use and Care Guide for information about
accessories available for your dryer.
"Y" connector
Long inlet hose
3
Advertisement
Table of Contents
