Whirlpool W10057363B User Manual page 21

6.
Rotate and reassemble outer window
assembly to trim ring
Notches
With the edge with 2 notches at the top, align the notches on
the outer window assembly with the tabs on the trim ring and
lower into place as shown in figure A.
Rotate the outer window assembly counterclockwise to lock
tabs into place (figure B). Using a Phillips screwdriver, secure
with 2 screws removed earlier.
ImPoRTAnT: Do not overtighten.
7.
Remove hinge and latch
Bottom
of door
A
Using a Torx
securing the latch plate and latch backing plate and the 5
screws holding the hinge assembly in place.
8.
Reinstall hinge and latch on
opposite sides
B
Using a Torx
backing plate, and hinge assembly on the opposite sides from
which they were removed.
Latch
T25 screwdriver, remove the 3 Torx screws
®
T25 screwdriver, reinstall the latch plate, latch
®
Hinge
21