ECR EMI AmericaSeries S1CG Installation, Operation And Maintenance Manual page 3

Single-zone and dual-zone side-discharge ductless split-system condensing units for r410 refrigerant
Table of Contents

Advertisement

WARNING
Completely read all instructions
prior to assembling, installing, oper-
ating, or repairing this product.
Inspect all parts for damage prior to in-
stallation and start-up. The EMI Ameri-
caSeries high efficiency condensing unit
must be installed ONLY by qualified
installation personnel.
DANGER
Tampering with this unit is danger-
. Tampering voids all warranties.
ous
attempt to modify or change this
NOT
unit in any way.
DANGER
The EMI AmericaSeries must:
Be connected to a properly grounded
electrical supply with the proper
voltage as stated on the rating plate.
Have proper overcurrent protection
(i.e. time-delay fuse/HACR Breaker)
as listed on the rating plate.
Failure to follow these instructions can
result in a fire, explosion, or electrical
shock causing property damage, personal
injury, or death.
P/N 240007754, Rev. A [051509]
S1CG/S1HG
• Installation, Operation and Maintenance Manual •
Read Before Proceeding
Recognize this symbol as an indication of
important safety information.
Single-Zone,
Safety Instructions
This manual is intended as an aid to
qualified service personnel for proper
installation, operation, and maintenance
of the EMI AmericaSeries high efficiency
condensing unit. Read these instructions
thoroughly and carefully before attempt-
ing installation or operation. Failure to
follow these instructions may result in
improper installation, operation, service,
or maintenance, possibly resulting in fire,
electrical shock, property damage, personal
injury, or death.
Read all instructions before using this
unit. Install or locate this unit only in ac-
DO
cordance with these instructions. Use this
unit only for its intended use as described
in this manual.
Check the rating plate on the unit before
installation to make certain the voltage
shown is the same as the electric supply to
the unit. The rating plate is located on the
front panel only.
This unit must be connected only to a
properly grounded electrical supply. Do
not fail to properly ground this unit.
Turn off the electrical supply before servic-
ing the unit.
Do not use the unit if it has damaged wir-
ing, is not working properly, or has been
damaged or dropped.
3
S2CG/S2HG
Dual-Zone
Made in the USA

Advertisement

Table of Contents
loading

Table of Contents