Weather forecast
sunny
fair to cloudy
Trend
rising
steady
2. Press and hold the MODE
button for approx. 3 seconds.
Set the atmospheric pressure
value and weather symbol.
Also see the section "Setting
the barometer and weather
symbol (prior to first use)".
Reading values
Switching between displays
(time/date/max. height
measured)
Press the MODE button
briefly to switch between the
displays.
Weather forecast
Based on the atmospheric pres-
sure measured during the past
12 hours, the weather station
determines a trend for further
development in the next 12 to
24 hours.
It then calculates a forecast
for forthcoming weather condi-
tions which is displayed by
means of weather icons.
Please note: Atmos-
pheric pressure-based
weather forecasts are
approximately 70%
accurate. You should
therefore never rely
solely on the weather
station, especially in
situations where the
weather is critical.
Barometer
The barometer shows the cur-
rent height value and atmos-
pheric pressure.
In addition, it saves the atmos-
pheric pressure trend for the
previous 12 hours. The trend is
displayed in the bar chart.
1. Press the MODE button until
the maximum height meas-
ured (meter) is shown in the
display.
overcast
Entering the current atmospheric pressure at your loca-
tion and the appropriate symbol for the current weather
is essential when setting up the device if the weather
falling
station is to work properly.
2. Briefly press the – button to
switch between the displays.
Temperature, air humidity
and measured height
The weather station measures
the current temperature, the
relative air humidity and cur-
rent height.
The device also calculates a
trend
mum and minimum values of
the last 12 hours.
Press the + button briefly to
switch between the displays.
Please note: At temper-
atures below 0°C no
values will be displayed
for the humidity.
If you carry the
weather station on
your body, your body
temperature will influ-
ence the measure-
ments. In order to
determine the correct
ambient temperature,
move the weather
station away from
your body for approx.
30 minutes.
Problems / solutions
Incorrect temperature
display
Malfunction due to direct sun-
light, air conditioner, heater or
similar. Move the device away
from the source of the problem.
Pale and incorrect displays
Battery is weak or contacts are
dirty. Clean the battery con-
tacts or replace the battery if
necessary.
Black display
The temperature is too high or
the display has been exposed
to direct sunlight for too long.
Move the device to a cooler
place where it is not exposed
to direct sunlight.
rain
and saves the maxi-
stormy
The display shows
unreasonable values
Remove the battery, wait for a
few seconds and restart.
Technical specifications
Model:
317 534
Batteries:
1x CR2032/3 V
Protection
type:
IPX3
Barometer range
300 to 1100 hPa
Display accuracy:
+/– 3hPa (within the range
750–1100 hPa, at 25°C)
Temperature range
Function range: (–20°C ~
+50°C / +4°F ~ +122°F)
General range that can be
shown: (–40 ~ +73°C //
LL will be shown below –40°C;
HH will be shown above +73°C)
Hygrometer
Function range: (30% ~ 90%)
rel. air humidity
General range that can be
shown: (0 ~ 99%)
Function temperature
–20 ~ +50°C (temperature
accuracy +/– 1 at 0 ~ +40°C)
Made exclusively for:
Tchibo GmbH, Überseering 18,
22297 Hamburg, Germany
In the course of product
improvement, we reserve the
right to make technical and
optical modifications to the
product.