Prior To Use; Charging The Battery; First Use; Switching The Headphones On/Off - Silvercrest SBTH 4.0 A1 User Manual And Service Information

SilverCrest SBTH 4.0 A1

Prior to use

Take the headphones and the accessories out of the packaging and remove all
packaging material completely.

Charging the battery

Before the first use or when the built-in battery is empty, you charge it as
follows:
 Connect the supplied USB charging cable (B) to the charging socket (7) and
a free USB socket of your computer when it is switched on or a USB power
supply (not supplied).
 The LED (9) lights up orange while the battery is being charged. When the
battery is fully charged, the LED (9) lights up blue.
The LED (9) flashes orange when the battery is low.

First use

Switching the headphones on/off

Switch on the headphones by pressing the ▸ll button (3) for approximately 3
seconds. The LED (9) flashes orange and thus indicates standby mode. If the
headphones were switched on for the first time and had never been connected
to a device, pairing mode is started automatically. The LED (9) alternates
between flashing blue and orange in pairing mode. Read the next section
when connecting your device.
Press the ▸ll button (3) for approximately 3 seconds to switch off the
headphones.

Connecting headphones

Proceed as follows to connect the headphones to your device:
 Switch off the headphones.
 Press the ▸ll button (3) for approximately 6 seconds to start pairing mode.
30 - English