Rewind Starter - Bombardier-Rotax 377 UL Operator's Manual

15.2) Rewind starter:
Check cord condition every 10 hours. Replace when worn or frayed.
To change the starterrope, follow the procedure outlined (the numbers stated in brackets refer
to the illustration),
First remove the rewind starter assembly from the engine.
Second, remove the snap ring <D, loop spring 0, circlip 8, pawl lock 0, and the pawl 0.
Pull out the starter rope fully to the end, hold starter housing 0 and rope sheave 6) together in
their position. There is an opening in the rope sheave. The key clamp
0
visible in the opening
has to be pushed ou t in the opposite sense of the pulling direction. Pull the rope out of the rope
sheave.
Then insert the new starter rope into the rope sheave, fit the key clamp in the same position as
it was and push it to be tight. Refit the parts 0, 0, 8, 0 and <D.
WARNING:
Do not remove spring container fJ, this might cause injuries.
Do not operate the engine if the rewind starter is defective.
Most starter problems are due to improper operation.
.'
III 37
3
i]ROTAX·1