Advertisement
3 Installation Instructions
To install the Reel Speed Control kit (MD #B6604 or 318001) on an A40DX or A40DX Grass Seed Auger Header,
follow this procedure:
CAUTION
Ensure shield lock engages in the open position as
shown at location (B) before letting go of shield.
1. Insert screwdriver or equivalent tool into opening (A) at
base of endshield and push to release latch.
2. Pull bottom and lift endshield until shield support (B)
engages bolt. Check that support (B) is engaged before
releasing hold on shield.
3. Non-Grass Seed Headers only: Disengage rubber
latch (A).
4. Non-Grass Seed Headers only: Open shield (B).
214679
Figure 3.1: Opening Endshield
Figure 3.2: Opening Driveline Shield
7
Revision B
Advertisement
