Crown CT36059 Original Instructions Manual page 11

Appliance components
1 LED light
2 LED light on / off switch
3 Body
4 Carrying handle
5 Manometer
6 "+" clamp
7 "-" clamp
8 Power cable
9 Nozzle
10 Air hose
11 On / off switch
12 Support
13 Replaceable tips *
14 Extension hose *
15 Ventilation slot
16 LCD display
17 Plug
18 Button "-"
19 Button "Set"
20 Button "+"
21 Nipple cap *
* Optional extra
Not all of the accessories illustrated or described
are included as standard delivery.
Installation and regulation of appliance
elements
Disconnect the appliance from the socket of the
cigarette lighter or vehicle accumulator before car-
rying out any procedures.
Do not draw up the fastening elements
too tight to avoid damaging the thread.
Accessories installation
fig. 1-2)
[CT36059, CT36060]
Connect / disconnect one of the replaceable tips 13 to
nozzle 9, as shown in fig. 1.
[CT36036]
Connect / disconnect hose 14 or one of the replace-
able tips 13 to nozzle 9, as shown in fig. 2.
Initial operating of the appliance
• Ensure that the voltage in the vehicle network cor-
responds with the data indicated on the appliance en-
closure�
• Check power cable 8� Replace it in case of dam-
ages�
• Check air hose 10 or extension hose 14� Replace
them in case of damages�
/ replacement (see
English
Switching the appliance on / off
[CT36059]
Switching on:
Press and release on / off switch 11 (see fig. 4.3).
Switching off:
Press and release on / off switch 11 (see fig. 4.3).
[CT36060, CT36036]
Switching on:
Set on / off switch 11 in the "ON" position (see
fig. 6.3, 8.3).
Switching off:
Set on / off switch 11 in the "OFF" position (see
fig. 6.4, 8.4).
Design features of the appliance
Temperature protection
Temperature protection prevents from damage to the
appliance, switching it off during excessive loads and
overheating� When temperature protection is activat-
ed, unplug the appliance from the mains, eliminate the
cause that triggered the protection, allow the appliance
to cool down, and then continue working�
Selection of measurement units
[CT36060]
Press button 19� The selected measurement units are
displayed on LCD display 16 (psi, kPa, bar)�
Pressure setting
[CT36060]
Press buttons 18 or 20 to set the desired pressure,
and then press button 19 to fix this value. The appli-
ance will automatically stop once the desired pressure
is reached�
LED light (see fig. 5, 7, 9)
LED light 1 makes it possible to work in case in low
light condition�
[CT36059, CT36060]
• Press and release LED light on / off switch 2 to
switch on the LED light (see fig. 5, 7).
• Press and release LED light on / off switch 2 to
switch off the LED light (see fig. 5, 7).
[CT36036]
• Set on / off switch 2 in the "ON" position to switch on
the LED light (see fig. 9.1).
• Set on / off switch 2 in the "OFF" position to switch
off the LED light (see fig. 9.2).
11