Advertisement
Brought to You by Augusta Flint
Your Pedal Car - Go Cart will require some minor assembly as indicated below. To assist you with assembly
and operation please refer to the Operational Figures and to the Assembly Diagram on page 5 and the
Parts List located on page 4.
Before assembling, remove any traces of the packing grease from the Go Cart and wipe all parts thoroughly
with a clean dry cloth. When cleaning do not use acetone, gasoline or paint thinner as these are dangerous to
you and may also cause damage to plastic and rubber parts.
Step 1)
Attach the Front Handle Assembly (B) to the Main Body (A). Slide the two (2) main tubes on
the Main Body (B) into the Front Handle Assembly. Line up the holes and insert one Bolt (F)
down through each side. Slide on Washer (F) and tighten into place with one Nut onto each
Bolt.
Step 2)
As necessary, attach the Handle Bar to the Front Handle Assembly (B) by lining up the holes
on the Handle Bar with the holes on the round plate at the uppermost end of the Front Handle
Assembly. Insert Bolts through the Handle Bar and round plate. Slide on Washers and
tighten into place with Nuts (F)-see Figure 1.
Step 3)
Slide each of the two front Wheels (D) onto the Axle. Slide on a Washer and screw in
Bolt (E).
Step 4)
Slide a Washer (E) onto each of the rear axles. Slide on the Wheels (D) and then slide on
another Washer for each Wheel (D) and Axle. Insert Bolt and tighten into place.
Step 5)
The position of the seat can be placed forward or to the back
of the Frame. The Seat (C) has a post at the bottom. Insert
the post into one of the square holes in the rear of the Go-Cart.
Set the Seat according to the needs of the driver - see Figure 2.
#42822
Assembly
Insert Bolts
Figure 1
Insert Seat Post
Figure 2-Inserting Seat Post
Page 3
Advertisement
