Tech Lighting Bath Tigris 700BCTIGOS26 CF Series Installation Instructions

Installation Instructions for
Tigris Mirror Oval Surface (Compact Fluorescent)
BATH COLLECTION
GENERAL PRODUCT INFORMATION:
This product is suitable for damp locations.
Bring 120 Volt power supply to the mirror in accordance
with local electrical codes.
This instruction shows a typical installation.
Install the Hardware
1A
BACKPLATE
3
3
1
1 Locate the studs on the wall where the mirror is going
to be mounted (Max 22-1/2" separation).
If necessary, use the center hole on the backplate to
2
position the backplate on the wall.
3 Use minimum of four slots to mount the backplate to
the studs with four screws and washers provided. Do
not drive the screws all the way in at this time.
3
SCREW
WASHER
2
CENTER
HOLE
3
STUD
1
C AUTION — RISK OF FIRE
This product requires installation by a qualified
electrician. Before installing be sure to read all
instructions and TURN THE POWER TO THE
ELECTRICAL BOX OFF.
1B
5
5
4 Bring the power line to one of the four circular holes on
the backplate.
While holding the backplate level and in the desired
5
position, tighten the four screws to secure it.
1
920BCTOVSCF
700BCTIGOS26_-CF
5
4
5
POWER LINE
1.1