Tech Lighting 700BCSIBS-CF Series Installation Instructions

Installation Instructions for
Siber Mirror Surface (Fluorescent)
BATH COLLECTION
GENERAL PRODUCT INFORMATION:
This product is suitable for damp locations.
Bring power supply lines to the mirror in accordance with
local electrical codes.
This instruction shows a typical installation.
Install the Hardware
1A
BACKPLATE
2
2
1
1 Locate the studs on the wall where the mirror is going
to be mounted (Max 28-1/4" separation).
Use minimum of four slots to mount the back plate to
2
the studs with four screws and washers provided. Do
not drive the screws all the way in at this time.
SCREW
2
2
WASHER
2
STUD
1
1
C AUTION — RISK OF FIRE
This product requires installation by a qualified
electrician. Before installing be sure to read all
instructions and DISCONNECT POWER TO THE
ELECTRICAL BOX.
1B
4
3
4
3 Bring the power line to one of the four circular holes on
the backplate.
While holding the back plate level and in the desired
4
position, tighten the four screws to secure it.
920BCSIBSCF
700BCSIBS_-CF_
4
POWER LINE
4
1.0