Advertisement
XC-1A Quick Start Guide (1.0)
2 Microsoft Windows Users
1. Download and configure the tools
Download the tools installer from the following URL:
http://www.xmos.com/downloads
Double-click the installer to run it. Follow the on-screen prompts to install
the tools on your PC.
2. Install the USB-to-JTAG drivers
Connect the XC-1A card to your development system using the USB cable
provided.
The New Hardware Wizard is displayed. If you are prompted to connect to
Windows Update, click No.
Click Next to proceed.
Select Install from list and click Advanced.
Browse to your tools installation folder, open the drivers subdirectory and
select the FTDI folder.
Click Next and follow the instructions on screen.
Click Finish to complete the driver installation.
The XC-1A card starts up and flashes the LEDs around the XMOS chip on the
card. The XC-1A card has four demonstrations which you can launch using
the push buttons—see Section 5.
3. Start the tools
To start the integrated development environment, Start
XMOS Desktop Tools 9.9
To use the command-line tools, Start
Tools 9.9
You are now ready to follow the XC-1A tutorial which explains how to write XC
programs for your XC-1A board. Download the tutorial from
http://www.xmos.com/published/xc1atut.
Desktop Tools Prompt.
www.xmos.com
XMOS Development Environment.
Programs
Programs
XMOS
XMOS
XMOS Desktop
3/7
Advertisement
