Cleaning The Overflow Container - Bosch PVQ F1 Series Instruction Manual

Resetting the saturation displays
If you have replaced the activated charcoal filters, you
should reset the saturation indicator so that the
display goes out.
After the appliance has been switched off,
Press and hold the symbol for the ventilation system
until an audible signal sounds.
The activated charcoal filter saturation indicator has
now been reset.
Removing metal grease filter
The metal grease filters filter the grease out of kitchen
steam. To keep it in good working order, the metal
grease filter must be cleaned regularly.
Also clean the inside of the hob extractor system
regularly. You can use a special degreaser to remove
stubborn dirt.
Remove the metal grease filter.
1.
Notes
– Grease may accumulate in the bottom of the
container. Hold the metal grease filter level to
prevent grease from dripping out.
– Make sure that the metal grease filter does not
fall and damage the cooktop.
Clean the metal grease filters in the dishwasher or
2.
with hot soapy water.~ "Cleaning the metal grease
filter" on page 27
If required, after removing the metal grease filter,
3.
remove the activated charcoal filter and clean the
appliance from the inside.
After cleaning, reinsert the dried metal grease filter.
4.
Cleaning the metal grease filter
Notes
Do not use aggressive, acidic or alkaline cleaning
■
products.
The metal grease filter can be cleaned in the
■
dishwasher or by hand.
By hand:
You can use a special degreaser to remove
Note:
stubborn dirt. It can be ordered via the online shop.
Remove the metal grease filter.
■
"
" lights up.
Soak the metal grease filter in hot soapy water.
■
Clean the metal grease filter with a brush and then
■
rinse it thoroughly.
Leave the metal grease filter to drain.
■
In the dishwasher:
Do not clean the metal grease filter together with
■
cookware if heavily soiled.
Place the metal grease filter in the dishwasher,
■
leaving plenty of space around it. Do not trap the
metal grease filter.
For best results, place the metal grease filter in the
■
dishwasher filter side down.

Cleaning the overflow container

Unscrew the overflow container with both hands.
1.
Note:
liquid from leaking out.
Empty the overflow container and rinse it out.
2.
If necessary, unscrew the screw and clean the
3.
overflow container without the screw in the
dishwasher.
Clean the overflow container before screwing it back
4.
into place.
Notes
Ensure that the supply to the overflow container is
■
not blocked. Once it has cooled down, remove any
objects that have entered the appliance. To do this,
remove the metal grease filter.
If liquid gets into the appliance from above, this is
■
collected in the overflow container. Unscrew the
overflow container and empty it.
Hold the overflow container level to prevent
Cleaning
en
27